Amonstar GLUE BINDING MACHINE Manual de usuario descargar pdf (Pagina 14)

图

Adjustment of the gluing roller

Step 1

1. Place a piece of sheet(thickness:0.8mm,320mm*

60mm)on to the platform

2. Place pile of 25mm—thickness paper on the right

position of the binder.

3. Push clamp plate and lock it.

4. Upturn the rotating unit(Platform),until spine of

book is upward.

5. Move the glue box after the glue is heated

6. Watch whether the glue roller is parallel to the

spine of book

7. If not parallel, please adjust bolt(4) until they are

parallel.

Step 2

8. Loosen the bolt(1)in picture B

9. Adjust bolt(3),until the roller touches the back surface of paper

10. Tighten the bolt(1)

11. Push the glue box to the other side

12. Loosen the bolt(2)in picture B

13. Adjust bolt(5),until the roller touches the back surface of paper

14. Tighten the bolt(2) in the picture B

15. Complete the steps as showed in picture 2( as Showed in the

attached picture)

16. After nishing the adjustment, tack back the sheet, and place another

pile of paper, glue it ,and watch whether the glue is evened,otherwise

more adjustment will be needed, following the same steps as above

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Amonstar GLUE BINDING MACHINE Manual de usuario Pagina 14