1. Malfunctions, causations and solution
Malfunctions Possible causations Solutions
I
The glue box can’t be’t bet be
heated
1.the fuse of power source is burned Replace a new fuseeplace a new fuse
2.The melting fuse tube is burntThe melting fuse tube is burnt melting fuse tube is burnt Replace a new tubeseplace a new tubes
3.the thermostat doesn’t work’t workt work Replace a new electro heat tubeeplace a new electro heat tube
4.the electro heat tube is broken Replace a new electro heat tube
II
The glue is not
layed on evenly or
Add glue
2.The gluing roller doesn’t rotateThe gluing roller doesn’t rotate gluing roller doesn’t rotate’t rotatet rotate
Fit the roller and tighten the bolt, don’t move the glue box untilit the roller and tighten the bolt, don’t move the glue box until’t move the glue box untilt move the glue box untiluntil
the temperature reaches to the point
3.the gluing roller doesn’t average’t averaget average
distance to the spine of book
Adjustable the gluing roller the gluing roller
4.the pressure of gluing roller is
Adjust the gluing roller
III
It’s hard to move the’s hard to move thes hard to move the
glue box
1.the glue isn’t heated well’t heated wellt heated well Run the glue box when it is heated
2.some sundries is in the box Be aware of cleaning the glue particulate
3.the glue slurry goes bad due to
long idleness
Heat and clear the remain glue slurry in the box, then add neweat and clear the remain glue slurry in the box, then add new
glue.
IV
The spine of book ise spine of book is
not well formed
1.The paper not neatly placedThe paper not neatly placedhe paper not neatly placed
2.Too short time to push and press
the cover template
Adjust the time of pushing and press the cover templatedjust the time of pushing and press the cover template
3.Misuse the cover template
Check whether the binding document matches the coverheck whether the binding document matches the cover
template
4.The pressure of two ends of the
cover template isn’t balanced’t balancedt balanced
Adjust and correct the pressure on two end
V
Poor fastness
of binding
1.too slow gluing Speed up gluingpeed up gluing
2.too slow or too short of pushing
and pressing the cover template
Rapid pushing and pressing, and master the proper time
3.poor quality of the glue Use the recommended gluese the recommended glue
4.wrong grain direction of paper Bind in the same grain direction of paperind in the same grain direction of paper
18
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales